1. Lowering the Screen (Module 3)
- Find the wall-mounted rocker switch (next to the lighting touchscreen).
- Press and hold the DOWN side until the screen is fully lowered.
- Put it back to center once the screen is all the way down.
2. Connecting Your Computer (Module 3)
- Use an HDMI cable to connect your laptop to the projector.
- Locate the power button on the projector (all the way to the left).
- Press it once. The projector takes about 30 seconds to warm up
- Select “Input C” if it’s not already showing the computer.
3. Turning On the Wireless Microphone (Module 2)
- Press and hold the power button until the light comes on.
- Speak into the mic to test. Adjust volume on the mixer (channels 9-10) if needed.
4. Adjusting the Lights (Module 1)
- Turn off the Working Lights.
- “Enable” the Stage Lights.
- Press “Home” and “Preset 4”
5. When You’re Done
- Turn off the projector using the power button.
- Power off the wireless mic.
- Disconnect your computer.
- Raise the screen by holding the UP side of the rocker switch.
- Turn off the Stage Lights (Enable).
- Press “Home” on the light controller.
- Press “Preset 1”.
